| Mon, 08 Sep 2014 10:03:00 +0200 |
Tom Gottfried |
Allow fractions without SQ-time interval (suspended sediment) to be loaded.
|
| Tue, 02 Sep 2014 14:46:20 +0200 |
Tom Gottfried |
Make sedimentload loadable as old calculation.
|
| Mon, 01 Sep 2014 09:43:55 +0200 |
Tom Gottfried |
Handle missing years in bed height differences without assuming an unknown year to be BC 1.
|
| Thu, 28 Aug 2014 12:00:52 +0200 |
Tom Gottfried |
Quoting is done elsewhere since rev 7021753b3797.
|
| Tue, 26 Aug 2014 17:16:21 +0200 |
Tom Gottfried |
With the exception of real calculation results, descriptions of sediment loads can all follow the same pattern.
|
| Tue, 26 Aug 2014 12:09:18 +0200 |
Tom Gottfried |
Metadata in datacage tooltips for sediment densities, bed heights, flow velocities and sounding widhts.
|
| Fri, 22 Aug 2014 18:00:35 +0200 |
Tom Gottfried |
Tooltip for sediment loads in datacage.
|
| Fri, 22 Aug 2014 17:43:36 +0200 |
Tom Gottfried |
Add SQ time interval to selection tree in datacage for sediment loads.
|
| Fri, 22 Aug 2014 13:19:02 +0200 |
Tom Gottfried |
Remove code duplications in sedimentload datacage.
|
| Fri, 22 Aug 2014 08:04:43 +0200 |
Tom Gottfried |
Format timestamps in datacage tooltip for porosities.
|
| Wed, 20 Aug 2014 17:47:58 +0200 |
Tom Gottfried |
Reconstruct facet description of sediment load longitudinal sections. i18n will follow.
|
| Wed, 20 Aug 2014 17:07:17 +0200 |
Tom Gottfried |
Reconstruct facet description of sediment load at measurement stations. i18n will follow.
|
| Wed, 20 Aug 2014 12:12:18 +0200 |
Andre Heinecke |
Remove todos about sedimentload_ls facet
|
| Wed, 20 Aug 2014 12:10:32 +0200 |
Andre Heinecke |
Configure SedimentLoadLSFacet
|
| Tue, 19 Aug 2014 18:46:13 +0200 |
Tom Gottfried |
Distinction by measurement station gives lots of duplicates, as we always get a whole longitudinal section.
|
| Fri, 15 Aug 2014 18:24:55 +0200 |
Andre Heinecke |
Change sedimentload factory from yields to loads.
|
